J4 ›› 2015, Vol. 42 ›› Issue (3): 54-60.doi: 10.3969/j.issn.1001-2400.2015.03.010

• 研究论文 • 上一篇    下一篇

90nm CMOS工艺下电压触发的ESD检测电路

杨兆年;刘红侠;朱嘉;费晨曦   

  1. (西安电子科技大学 宽禁带半导体材料与器件教育部重点实验室,陕西 西安  710071)
  • 收稿日期:2014-01-12 出版日期:2015-06-20 发布日期:2015-07-27
  • 通讯作者: 杨兆年
  • 作者简介:杨兆年(1986-),男,西安电子科技大学博士研究生,E-mail: e_yangzhaonian@sina.com.
  • 基金资助:

    国家自然科学基金资助项目(61376099, 11235008);教育部博士点基金资助项目(20130203130002, 20110203110012);航天808所基金资助项目(20140418)

Voltage triggered ESD detection circuits in a 90nm CMOS process

YANG Zhaonian;LIU Hongxia;ZHU Jia;FEI Chenxi   

  1. (Ministry of Education Key Lab. of Wide Band-Gap Semiconductor Materials and Devices, Xidian Univ., Xi'an  710071, China)
  • Received:2014-01-12 Online:2015-06-20 Published:2015-07-27
  • Contact: YANG Zhaonian

摘要:

提出两种90nm 1V CMOS工艺下电压触发的静电放电检测电路.电压触发的静电检测电路避免了纳米级工艺中的MOS电容栅极漏电问题.该检测电路包含一个反馈回路,提高了检测电路的触发效率,同时增加了反馈关断机制,在芯片工作时检测电路由于某些特殊因素误触发后,仍然可以自行关断,而不会进入闩锁状态.在3V静电放电仿真时,该电路能产生28mA触发电流,以开启箝位器件来泄放静电电荷.在25℃正常电压下工作时,漏电流仅为42(45)nA.仿真结果表明,该检测电路可成功用于纳米级CMOS工艺的集成电路静电保护.

关键词: 反馈, 检测电路, 静电放电, 电压触发

Abstract:

Two voltage triggered electrostatic discharge (ESD) detection circuits are proposed in a 90nm 1V CMOS process, which can avoid the gate leakage current issue in the nanometer CMOS process. The proposed circuits include feedback loops to enhance the ESD trigger efficiency, and also add turn-off mechanisms, which can turn off the feedback when they are turned on for some unknown reasons and cannot be latched on. Under 3V ESD simulation, the circuits can inject 28mA trigger currents into the clamp device. Under the 25℃ normal operating condition the leakage current is 42nA and 45nA , respectively. Simulation result shows that the circuits can be successfully used in nanometer CMOS process ESD protection.

Key words: feedback, detection circuit, electrostatic discharge (ESD), voltage triggered