[1] IEC TECHNICAL COMMITTEE 77. Electromagnetic Compatibility-testing and Measurement Techniques-Electrical Fast Transient/Burst Immunity Test: IEC 61000-4-4 [S]. Geneva: IEC, 2004.
[2] FONTANA M, HUBING T. Characterization of CAN Network Susceptibility to EFT Transient Noise [J]. IEEE Transactions on Electromagnetic Compatibility, 2015, 57(2): 188-194.
[3] CANIGGIA S, DUDENHOEFFER E, MARADEI F. Full-wave Investigation of EFT Injection Clamp Calibration Setup [C]//Proceedings of the IEEE International Symposium on Electromagnetic Compatibility. Piscataway: IEEE, 2010: 602-607.
[4] HALLON J, BITTERA M. Directivity of Capacitive Clamp for EFT Pulses Injection [C]//Proceedings of the 2014 24th International Conference on Radioelektronika. Piscataway: IEEE, 2014: 6828459.
[5] 张逸飞, 杨武, 薛艳红. 关于EFT试验中容性耦合夹使用的注意事项 [J]. 现代测量与实验室管理, 2014, 16(1): 16-20.
ZHANG Yifei, YANG Wu, XUE Yanhong. Application of the Capacitive Coupling in EFT Test [J]. Advanced Measurement and Laboratory Management, 2014, 16(1): 16-20.
[6] 李玉龙, 王丽芳, 廖承林, 等. 屏蔽层对 CAN 总线抗干扰能力影响的研究 [J]. 汽车技术, 2009, 21(10): 30-34.
LI Yulong, WANG Lifang, LIAO Chenglin, et al. Research on Anti-interference Ability of Shielding Layer on Vehicle CAN Bus [J]. Automobile Technology, 2009, 21(10): 30-34.
[7] 史军刚, 李小平, 谢锴, 等. 非接触电容耦合式信号传输方法 [J]. 西安电子科技大学学报, 2015, 42(4): 14-19.
SHI Jungang, LI Xiaoping, XIE Kai, et al. Capacitively Coupled Contactless Signal Transfer Method [J]. Journal of Xidian University, 2015, 42(4): 14-19.
[8] MUSOLINO F, FIORI F. Modeling the IEC 61000-4-4 EFT Injection Clamp [J]. IEEE Transactions on Electromagnetic Compatibility, 2008, 50(4): 869-875.
[9] CERRI G, DR LEO R, PRIMIANI V M. Electrical Fast-transient Test: Conducted and Radiated Disturbance Determination by a Complete Source Modeling[J]. IEEE Transactions on Electromagnetic Compatibility, 2001, 43(1): 37-44.
[10] CANIGGIA S, DUDENHOEFFER E, MARADEI F. Full-wave Investigation of EFT Injection Clamp Calibration Setup [C]//Proceedings of the IEEE International Symposium on Electromagnetic Compatibility. Piscataway: IEEE, 2010: 602-607.
[11] PAUL C R. Introduction to Electromagnetic Compatibility [M]. New York: Wiley-Interscience, 1992.
[12] YOUNG B. Return Path Inductance in Measurements of Package Inductance Matrix [J]. IEEE Transactions on Components Packaging and Manufacturing Technology B, 1997, 20(1): 50-55.
[13] EISENSTADT W R, EO Y. S-parameter-based IC Interconnect Transmission Line Characterization [J]. IEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1992, 15(4):483-490.
[14] PAUL C R. Analysis of Multiconductor Transmission Lines [M]. NewYork: Wiley, 1994. |