Electronic Science and Technology ›› 2022, Vol. 35 ›› Issue (6): 76-82.doi: 10.16180/j.cnki.issn1007-7820.2022.06.012

Previous Articles     Next Articles

Design of VFTO Measuring System at the Metal Flange Hole

LIANG Shiqi,ZHANG Wenbin   

  1. Faculty of Mechanical and Electrical Engineering,Kunming University of Science and Technology, Kunming 650500,China
  • Received:2021-01-19 Online:2022-06-15 Published:2022-06-20
  • Supported by:
    China Southern Power Grid Company Limited Project(KTKM2018203)

Abstract:

The measurement sensor of the built-in sensor for VFTO is large in size and difficult to install, and cannot be applied to GIS in operation. In order to solve these problems, the VFTO measurement system for GIS metal flange holes is designed. The system adopts the scheme of combining FPC capacitor voltage divider and secondary resistance-capacitor voltage divider to realize VFTO measurement with external miniaturization of GIS. According to the size of the metal flange hole and the performance requirements of the measurement system, the structure and size of the FPC are designed, and the capacitance partial pressure probe is developed. In order to improve the performance of the measurement system, a broadband resistance-capacitance voltage divider is designed, and the matching resistance and the parameters of the coaxial cable are optimized through actual measurement. The results show that the bandwidth of VFTO measurement system is 22.45 Hz~111.45 MHz, and voltage division ratio is 112 790, indicating that the proposed system can accurately trace the source waveform and meet the requirements of VFTO measurement.

Key words: gas insulated switchgear, very fast transient overvoltage, resistance-capacitance divider, capacitive voltage divider, metal flange casting hole, amplitude-frequency response, impulse response, bandwidth

CLC Number: 

  • TP212.1