›› 2012, Vol. 25 ›› Issue (11): 82-.

• 论文 • 上一篇    下一篇

配电网直流定位法探测器的研究与实现

张欣,李宝兰,曹盛   

  1. (1.湖南省电力公司 常德电业局,湖南 常德 415001;2.湖北省宜昌市供电公司 调度通信中心,湖北 宜昌 443000;3.华北电力大学 电子与通信工程系,河北 保定 071003)
  • 出版日期:2012-11-15 发布日期:2013-01-23
  • 作者简介:张欣(1963—),男,工程师。研究方向:电力生产管理。李宝兰(1973—),女,工程师。研究方向:调度通信。曹盛(1986—),男,硕士研究生。研究方向:配电网故障定位。

Research on and Implementation of DC Location Detector in Distribution Network

ZHANG Xin,LI Baolan,CAO Sheng   

  1. (1.Changde Power Bureau,Hunan Electric Power Company,Changde 415001,China;
    2.Scheduling Communication Center,Hubei Yichang Electric Power Company,Yichang 443000,China;3.Department of Electronics and Communication Engineering,North China Electric Power University,Baoding 071003,China)
  • Online:2012-11-15 Published:2013-01-23

摘要:

在配电网单相接地故障定位中,由于水泥杆接地故障的存在以及导线分布电容的影响,使得C行行波法和交流注入法不能有效定位。直流定位方法是在停电离线状态下,向故障相注入直流信号,然后手持直流信号检测器沿线路检测该直流信号,确定故障点的具体位置。文中对直流信号探测器的原理与组成进行了阐述,并对直流信号的注入进行了仿真。仿真结果表明,该方法是有效、可行的。

关键词: 配电网, 故障定位, 直流注入法, 直流定位法

Abstract:

In distribution network fault location,the existence of the cement pole earth fault and the effect of wire distribution capacitance make it difficult to locate by the C type traveling wave method and the AC signal injection method.DC signal injection method works in time of line power failure,by which a DC signal is injected into the fault for the maintenance personnel to detect the DC signal by holding a DC signal detector along the road to determine the specific location of the point of failure.The principle of the DC signal detector and composition are described,and the injection of the DC signal is simulated.Simulation results prove the feasibility of our method.

Key words: distribution network;fault location;DC signal injection method;DC location method

中图分类号: 

  • TM711.2